Steel Grating 
Home  >   Products  >   Steel Grating 

Fabrication Categories

Inquire Now
Fabrication Categories

Standard Panels

Steel grating panels are manufactured in standard sizes, they are then cut down and fabricated to suit client specifications.


Economic Fabrication

Panels can be joined together to increase the width however to produce the grating in the most economical way, grating should be manufactured as standard in 1 meter nominal widths. The most economical way to manufacture the grating is to maintain the standard width whenever possible and finish your walkway with a make up panel.


Fabrication Categories

Basic Fabrication Categories

cutting & binding

Standard Panels are fabricated into smaller pieces with no cut-outs or panel notching. Panel ends are bound using binding bars of the same depth as the bearing bars. Kick flat / Toe Plate can be used in replace of binding bars at an additional cost. Cutting and binding is the most cost effective fabrication method.


Fabrication Categories

simple shaping layouts

Simple layouts would generally be from standard width panels but can be areas with non-standard widths to suit applications. Within these panels a nominal amount of shaping and cut-outs could exist. Open ends and shaping cut-outs are bound with binding bars of the same depth as the load-bearing bars. Kick flat / Toe Plate can be used in replace of binding bars at an additional cost.


Fabrication Categories

Complex shaping layouts

Complex shaping layouts would generally be from standard width panels but can be areas with non-standard widths to suit applications. Within these panels there would be a large amount of panel shaping and cut-outs.

Open ends and shaping cut-outs are bound with binding bars of the same depth as the load-bearing bars. Kick flat / Toe Plate can be used in replace of binding bars at an additional cost.

Need help with Technical Specifications?

Click here to find more information. Alternatively, you can call 86 0318 7026632 where an advisor would be happy to help.


Technical Information

Yilida offer a full fabrication service providing cut to length panels with bound edges, or fully shaped panels to suit client drawings in accordance with BS4592:2006 with manufacturing tolerances of +0mm/-5mm.


Copyright © Anping Yilida Metal Wire Mesh Co., Ltd. All Rights Reserved   
Sitemap | Technical Support: